PUMP-TANDEM, VAR DISPL

4355063

Model code: MPT-035-D-C-Y-A-E-NN-B-A-A-A-BJJ-DT-A-FF-B-C-A-A-BJJ-DT-A-FF-N-GNB-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	035	35 cc/rev (2.1 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	C	Tapered, 1 inch dia, 1.5 in/foot, square key
Rotation and valve plate	Y	Left hand (counter-clockwise), standard
Charge pump displacement	A	None
Charge pressure relief valve setting	E	11 bar (160 psi)
Filtration	NN	None - without charge pump
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, front pump	DT	Right side, Bobcat bracket
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, rear pump	DT	Right side, Bobcat control bracket (4440414), no lift bracket
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	N	SAE A - 9 tooth integral, for use with gear pump
Special features (non-hardware)	***	None
Special hardware features	GNB	GNB

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm