PUMP-TANDEM, VAR DISPL MPT044D

4445036

Model code: MPT-044-D-C-M-A-E-NN-B-A-A-A-BHH-DL-A-FF-B-C-A-A-BHH-DL-A-FF-D-NNN-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Auxillary mounting pad	D	SAE A - aux flange, 11 tooth 16/32 spline coupling
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Bypass valve, front pump	A	Bypass valve
Bypass valve, rear pump	A	Bypass valve
Charge pressure relief valve setting	E	11 bar (160 psi)
Charge pump displacement	A	None
Control orifice diameter, front pump	FF	None
Control orifice diameter, rear pump	FF	None
Control type, front pump	DL	Direct displacement control left side
Control type, rear pump	DL	Left side, lift bracket top right
Displacement, front pump	A	Full displacement
Displacement, rear pump	A	Full displacement
Filtration	NN	None - without charge pump
Front seal group	A	Shaft seal for manual displacement control-front section
Handle position, front pump	A	None
Handle position, rear pump	A	Not applicable
Input shaft	C	Tapered, 1 inch dia, 1.5 in/foot, square key
Product	MPT	Tandem pump
Rear seal group	C	Shaft seal direct displacement
Rotation and valve plate	M	Right hand (clockwise)
Special features (non-hardware)	***	None
Special hardware features	NNN	Special hardware - none, black paint, Danfoss tag
Swashplate	B	Standard direct displacement swashplate
Swashplate group, rear pump	B	Swashplate group-standard
System pressure protection, front pump	BHH	300 bar (4350 psi) / 300 bar (4350 psi)
System pressure protection, rear pump	BHH	300 bar (4350 psi) / 300 bar (4350 psi)
Type	D	35cc & 44cc product type

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm