PUMP-TANDEM, VAR DISPL MPT044D

4445115

Model code: MPT-044-D-C-4-R-H-BD-B-A-A-A-BJJ-DL-A-FF-B-C-A-A-BJJ-DL-A-FF-1-NNN-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	C	Tapered, 1 inch dia, 1.5 in/foot, square key
Rotation and valve plate	4	Left hand (counter-clockwise), low force
Charge pump displacement	R	16.4 cc/rev
Charge pressure relief valve setting	H	24.0 bar (348 psi)
Filtration	BD	Suction filtration with charge pump
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, front pump	DL	Direct displacement control left side
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, rear pump	DL	Left side, lift bracket top right
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	1	SAE B - 13 tooth (integral)
Special features (non-hardware)	***	None
Special hardware features	NNN	Special hardware - none, black paint, Danfoss tag

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm