PUMP-TANDEM, VAR DISPL MPT044D

4445122

Model code: MPT-044-D-A-5-R-2-BA-B-A-A-A-BJJ-DR-A-FF-B-C-A-A-BJJ-DR-A-FF-K-NNN-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	A	15 tooth 16/32 spline
Rotation and valve plate	5	Right hand (clockwise), low force
Charge pump displacement	R	16.4 cc/rev
Charge pressure relief valve setting	2	20 bar (290 psi)
Filtration	BA	Remote pressure filtration without bypass
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, front pump	DR	Direct displacement control right side
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, rear pump	DR	Right side, lift bracket top right
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	K	SAE A - 11 tooth, with case drain, no gear pump
Special hardware features	NNN	Special hardware - none, black paint, Danfoss tag
Special features (non-hardware)	***	None

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm