PUMP-TANDEM, VAR DISPL

4445253

Model code: MPT-044-D-G-W-A-E-NN-B-A-A-A-BRR-DR-A-FF-B-C-A-A-BRR-DR-A-FF-P-GPA-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	G	15 tooth 16/32 spline, long, with snap ring grooves
Rotation and valve plate	W	Right hand (clockwise), standard
Charge pump displacement	A	None
Charge pressure relief valve setting	E	11 bar (160 psi)
Filtration	NN	None - without charge pump
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BRR	325 bar (4712 psi) / 325 bar (4712 psi)
Control type, front pump	DR	Direct displacement control right side
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BRR	325 bar (4712 psi) / 325 bar (4712 psi)
Control type, rear pump	DR	Right side, lift bracket top right
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	P	SAE A - 11 tooth, with case drain
Special hardware features	GPA	GPA
Special features (non-hardware)	***	None

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm