PUMP-TANDEM, VAR DISPL

4355036

Model code: MPT-035-D-G-W-A-N-NN-B-A-A-A-BDD-DR-A-FF-B-C-A-A-BDD-DY-A-FF-N-GNN-***

This product has been discontinued and is no longer available. At this time, there is no direct replacement product.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	035	35 cc/rev (2.1 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	G	15 tooth 16/32 spline, long, with snap ring grooves
Rotation and valve plate	W	Right hand (clockwise), standard
Charge pump displacement	A	None
Charge pressure relief valve setting	N	9 bar (130 psi)
Filtration	NN	None - without charge pump
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BDD	210 bar (3045 psi) / 210 bar (3045 psi)
Control type, front pump	DR	Direct displacement control right side
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BDD	210 bar (3045 psi) / 210 bar (3045 psi)
Control type, rear pump	DY	Left side, lift bracket bottom left
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	N	SAE A - 9 tooth integral, for use with gear pump
Special hardware features	GNN	GNN
Special features (non-hardware)	***	None

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm