PUMP-TANDEM, VAR DISPL

4445074

Model code: MPT-044-D-C-4-A-E-NN-B-A-A-A-ERR-DS-A-FF-B-C-A-A-ERR-DN-A-FF-P-GRK-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	C	Tapered, 1 inch dia, 1.5 in/foot, square key
Rotation and valve plate	4	Left hand (counter-clockwise), low force
Charge pump displacement	A	None
Charge pressure relief valve setting	E	11 bar (160 psi)
Filtration	NN	None - without charge pump
Swashplate	B	Standard direct displacement swashplate
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	ERR	325 bar (4712 psi) / 325 bar (4712 psi) fast check response
Control type, front pump	DS	Left side, Bobcat bracket
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	B	Swashplate group-standard
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	ERR	325 bar (4712 psi) / 325 bar (3712 psi) fast check response
Control type, rear pump	DN	Left side, Bobcat control mounting bracket (4440414), no lift bracket
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	P	SAE A - 11 tooth, with case drain
Special hardware features	GRK	GRK
Special features (non-hardware)	***	None

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm