PUMP-TANDEM, VAR DISPL MPT044D

83036517

Model code: MPT-044-D-A-2-A-H-NN-J-A-A-A-BJJ-DL-A-FF-J-C-A-A-BJJ-DL-A-FF-1-NGD-***

This product has been discontinued.

The product is no longer available for purchase, but you can still find information about it, including service manuals, drawing etc.

If you're looking for a similar product, you can check out other options within the same product type by visiting the product type page.: Series 40 M35 and M44 tandem axial piston pumps

Tools

Characteristic	Value	Description
Product	MPT	Tandem pump
Base displacement	044	44 cc/rev (2.65 cu in/rev)
Type	D	35cc & 44cc product type
Input shaft	A	15 tooth 16/32 spline
Rotation and valve plate	2	Left hand (counter-clockwise)
Charge pump displacement	A	None
Charge pressure relief valve setting	H	24.0 bar (348 psi)
Filtration	NN	None - without charge pump
Swashplate	J	3/4 inch square trunnion with 3/8-16 tapped hole
Front seal group	A	Shaft seal for manual displacement control-front section
Displacement, front pump	A	Full displacement
Bypass valve, front pump	A	Bypass valve
System pressure protection, front pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, front pump	DL	Direct displacement control left side
Handle position, front pump	A	None
Control orifice diameter, front pump	FF	None
Swashplate group, rear pump	J	Swashplate group-3/4 square trunnion tapped
Rear seal group	C	Shaft seal direct displacement
Displacement, rear pump	A	Full displacement
Bypass valve, rear pump	A	Bypass valve
System pressure protection, rear pump	BJJ	345 bar (5000 psi) / 345 bar (5000 psi)
Control type, rear pump	DL	Left side, lift bracket top right
Handle position, rear pump	A	Not applicable
Control orifice diameter, rear pump	FF	None
Auxillary mounting pad	1	SAE B - 13 tooth (integral)
Special hardware features	NGD	Special hardware - dark grey paint, Bobcat tag
Special features (non-hardware)	***	None

Characteristic	Value
Proposition 65	Cancer and Reproductive Harm